Welcome To Ford Forums Online
Ford Forums
Ford Tech Forums
General Forums & Ford Information Database
Marketplace
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Car Clubs
Latest Posts
-
Cleaned Carb... replaced needle & seat.... not float. Car starts fine, gas gets to engine. After running approximately 2 minutes, gas overflows through carb vent. Since seat is new, nothing is blocking the needle from sealing. advice? ps 260v8 63 Futura2 replies 50 views
-
so with the repacment of the driver side door hinge, i had to take off the old weathered cracked up door panel and arm rest. now i will be in the look out for a new set of arm rest and i plan to make the door panel. has any of yall made your door panel and covered it with fabric?12 replies 1K views
-
Hello to all forum members, I'm new at this please bare with me. I have a 99 Windstar LX, when I got it the check engine light was on so I proceeded to do what I know. I replaced the wires, coil pack, plugs, and all 4 O2 sensors. Check light went off but shortly came back on. I have a wire...9 replies 422 views
-
On my 1964 Falcon, I am replacing the original 2 speed Ford-O-Matic with a later C4. The FOM was air-cooled--not lines to the radiator--no transmission cooler in the radiator. I would like to keep that original radiator. How large of a cooler do I need to install in front of the radiator to...4 replies 50 views
-
I sent the lifters and cam from my 200 SIX to Oregon Cam grinders via AS postal service. The USPS lost the package for over a month. The packaging was damaged, but all the contents were there--or were they? 2 of the lifters were missing the retaining springs that hold the push rod cup in the...7 replies 75 views