at the master switch, make sure you have 12v at the PIn20-RD/LB wire with the key in the RUN position. that wire is what feeds power to the other switches. with it being a police vehicle perhaps they disconnected that lead.
2001 cvpi
I have a 2001 CV Police Interceptor. I was lucky in that the connecting hardware for the rear doors was included and now the rear doors can be opened from the inside.
However, the power windows only work from the drivers controls. I have checked the window lock switch and that wasn't it. I cannot control the power windows from any other position. I have check the switch and they appear to be connected.
Does anyone have an idea how to get the windows to work again? What did they disconnect in the 2001 CVPI?
Thank you.
However, the power windows only work from the drivers controls. I have checked the window lock switch and that wasn't it. I cannot control the power windows from any other position. I have check the switch and they appear to be connected.
Does anyone have an idea how to get the windows to work again? What did they disconnect in the 2001 CVPI?
Thank you.
1 - 3 of 3 Posts
Another place too look is at the bottom of the B pillar (between the driver side doors) at the bottom is the harness that operates the door electrics..Check that the harness is plugged in or a wire is not cut.
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ford Automobiles
A forum community dedicated to Ford owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Recommended Communities
