Ford Automobiles banner

1 - 9 of 9 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
So upon replacing the spark plugs and valve cover gasket I tried to take off the cht sensor and it wouldn't move . The center release broke and I had to peel it off using an engine pick and realized that on the back of the female plug there was a yellow goo kinda like a glue keeping it on so I had to finish breaking the male end to get it to come off. Any advice on fixing this?
46234
 

·
Super Moderator
Joined
·
13,486 Posts
Here is the part



Follow directions in the vid for R&R

Action



F
 

·
Super Moderator
Joined
·
13,486 Posts
From the wire harness?

The male end would be the sender.
The female end would be attached to the engine wiring harness.
If so this might work not sure

Action
 

·
Super Moderator
Joined
·
13,486 Posts
Make sure because I did a very quick search.

Action
 

·
Super Moderator
Joined
·
13,486 Posts
Crimping can work. Then fill the joint with RTV.
Solder with heat shrink would be a more permanent connection.

All EEC sensors operate off of 5 volts and just a tad bit of current.

Action
 
1 - 9 of 9 Posts
Top