[Jonzo77]

looking for a 4V intake and carb, from any 289, 302/5.0, or 351W.

i want a traditional factory look, with factory parts, and don't want to go aftermarket...

 

[Zephyrman]

I may be able to find you an intake, I'll make some calls.

 

[Jonzo77]

sweet! thanks buddy!:yikes:

 

[VAMP_77]

original

u can find almost any aftermarket and paint it 'ford blue' and not too many people will notice it.. especially if you have the 14" air cleaner. Well, if you change your mind on the 'aftermarket' thing. I might be swapping my weiand out for a edelbrock rpm air gap.... only thing else you'd need is a 1406 edelbrock carb ​

 

[Jonzo77]

na. it stays silver, and i like having the ford part numbers on it.

 

[Feared_Futura]

not wanting to thread jack but if anyone has any aftermarket or not i need a 4 barrel intake for my 302. i didn't think the 351 windsor intake would fit a 302 will it? i thought it was too wide.

 

[Stymees'mont]

351w intake WILL NOT fit a 302.

 

[Jonzo77]

351w intake WILL NOT fit a 302.

even if you use the 351W heads?

 

[Stymees'mont]

No. Not even with 351w heads. The blocks are different in the valley. The 351w is taller....making the intake wider on the 351w. The 351w heads are very much the same as 302 heads. Its the head bolt sizes between the two heads that make them different.

 

[Ashzo77]

you con make a 302 intake fit a 351, but you'd need spacers, right?

 

[Stymees'mont]

But why would you...just use the correct intake.

 

[Ashzo77]

well, lets say you have a fuel injected truck engine, and the only carb intake you have is from a 302...
oh, and you're on an extremely low budget

 

[Stymees'mont]

Still be cheaper to get the correct intake. You can find them cheap enough and easier then spacers or have spacers made.