[codygallardo6]

Hello everyone,

I had to replace the engine wiring harness in my 2014 Ford Fusion and I ran into an issue when trying to connect the 20 pin connector. The piece that the 20 pin connector is supposed to connect to on the transmission is broken on the top and the connector won't stay connected. How can I replace this or do you recommend I take it to a mechanic?

Thank you all in advance!

 

[Action]

Welcome to the FFO!

That connector half, if broken will need to be replaced. Unless it can be tie wrapped
It looks like that connector is part of a conductor plate. And this might be it
Automatic transmission conductor plate 6F35 08-up | 9L8Z7G276A CV6Z7G276A CV6Z7G276B 9L8P-7G276-CA (maktrans.net)

You would want to contact them before placing an order to confirm. And you may need data from the transmission or vehicle to confirm

Good luck and post back with your result

Action