Ford Automobiles banner
1 - 4 of 4 Posts

·
Administrator
Phoenix, AZ 85008
Joined
·
16,316 Posts
Most of the time not that difficult.

Typically there are black phillips head screws into the upper leading edge of the bezel. Sometimes on the sides and lower part.
Once the bezel is removed the instrument cluster is usually held in place by a number of smaller hex head screws.
After those have been removed the cluster is still attached in the back by the speedo cable and a wiring harness into the printed circuit board.
Move the cluster out a little to disconnect those.

Recommendation - if this is your first time take a picture for each piece you removed for reference at re-assembly.

Picture is an empty cluster panel.
Automotive exterior Rim Automotive wheel system Wood Gas


Action
 

·
Administrator
Phoenix, AZ 85008
Joined
·
16,316 Posts
Vehicle Steering part Gauge Motor vehicle Car
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top