Ford Automobiles banner
1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
I have a 70 model 302 in my fairlane, the intake is held on by 8 bolts and 4 nuts that tighten down to 4 studs, i want to buy new intake bolts but all i find is a kit with all bolts. Do i need to remove the factory studs to use bolts or is there a intake kit somewhere that has nuts also. thanks for any help you can provide
 

·
Registered
Joined
·
534 Posts
crowe, i believe you can do either. just check the length. the time i did that i used a bolt that was the same length as the stud (i was a kid) and of courst they didnt even get close.
 
1 - 2 of 2 Posts
Top