Ford Automobiles banner
1 - 2 of 2 Posts

·
Registered
Joined
·
98 Posts
that is not a 8 or 9 inch that was in your falcon i think that is a mopar rear axel i dont think your backing plates will work if your original is a ford rear need some more info and pictures of both
 

·
Registered
Joined
·
98 Posts
it
That looks like a 6 cyl rear but hard to tell with that picture being so close. Also can you take another after turning the diff 90 degrees? If you removed the 4 bolts on the axle and there a was a plate that is separate from the backing plate then you don't have c clips. That plate would be for holding the axles in. And most likely the bearing is just rusted inside the housing. You would need a slide hammer with the attachment to mount to the lug bolts and slide hammer it out. make sure the car is on solid stands!

Steve
its not a ford rear end you cant take a rear cover off unless its an 8.8 rear but there is no c clips there is no axis hole
 
1 - 2 of 2 Posts
Top