Ford Automobiles banner
1 - 10 of 10 Posts

·
Registered
Joined
·
112 Posts
Discussion Starter · #1 ·
doing the trunk mod on the 1964 ford fairlane to fit the rod & custom rc 114 found a u tube video was for different car but measurement are similar to get you started im spot welding mine in not gonna weld around the whole piece like they did i will use seam sealer when done plus i want to secure fuel tank bracket to the new pan
Motor vehicle Hood Bumper Automotive tire Automotive exterior
Light Automotive tire Automotive exterior Motor vehicle Gas
Automotive lighting Fixture Gas Tints and shades Vehicle door
Automotive tire Bumper Motor vehicle Automotive exterior Gas
Automotive tire Motor vehicle Tire Bumper Automotive exterior
Automotive tire Vehicle Bumper Automotive exterior Motor vehicle
 

·
Registered
Joined
·
112 Posts
Discussion Starter · #6 ·
its not to bad to do couple of weekends my problem is i had a lot of floor pan repair and front wheel wells and tunnel for the tko transmission then all this paint work im also doing rod and custom front with coil overs never done a suspension mod like this but it is very do able for a confidant mechanic my problem is i find it hard to find time to work on my own cars anymore need any advise ill do my best to help you out
 

·
Administrator
Phoenix, AZ 85008
Joined
·
16,568 Posts
Nice work!!!!!
I bet you are feeling good about it.


Action
 

·
Registered
Joined
·
112 Posts
Discussion Starter · #10 ·
yup tried to finish setting up rear axel but the upper sleeves are to long need to be 6.5 inches they sent 8 inch so i called and they said they would send rite out but have not seen them yet
 
1 - 10 of 10 Posts
Top