[Pletchaj]

Does anyone have a picture of a late 80's early nineties ford 5.8l motor ... most importantly i am trying to find out if the intake are the same. For i bought a k and n intake and a bbk throttle body for the 5.0 and i want to make sure a 5.8 can use the same equipment. Thanks.

 

[mark v]

Depends if the parts were for a 5.0 HO engine, I dont think the intake will work. I didnt know K+N made intakes for engines?

 

[andfab99]

The 5.8 is taller and wider than the 5.0 so the intake is different.

 

[Pletchaj]

Depends if the parts were for a 5.0 HO engine, I dont think the intake will work. I didnt know K+N made intakes for engines?

ok air intake and i sent sent emails to the manufacturer to confer with them

 

[mark v]

Yeah when did K+N start making intakes?

I know they make air filters and cold air kits but not Intakes!

 

[Jonzo77]

i think he means the kit, mark...

 

[Jonzo77]

if you're talking about bolting the throttle body... wait. is it for a truck or car? two totally different animals there. as far as i know the throttlebody should fit correctly, the cold air kit you can see if that goes on or not with the throttle in your hand...

 

[mark v]

OK fresh air/cold air kit. When I hear intake I think of Intake manifold.

 

[Jonzo77]

i usually do, but that was the only thing that would make sense

 

[Pletchaj]

yeah it a cold air kit ... or performace air intake whatever ... were all on the same page ... so there should be no big diffrence in swaping out the motor than from a Truck 5.0 to a truck 5.8 then?

 

[Jonzo77]

are they both twin bore, or just the single large bore throttle?

 

[Pletchaj]

both twin

 

[Jonzo77]

then yeah. they should interchange without any issues